Machine Tending Cell: The Eight Things to Measure Before You Ask for a Quote
Part weight, cycle time, chuck height, door type, chip protection, buffer size, operator access and voltage. Get these wrong and the cell is rebuilt on site.
Measure the Machine, Not the Robot
The arm is the cheap part of a tending cell. What decides the design: the height of the chuck or the table from the floor, whether the door opens sideways or up, how far the part has to travel from the magazine to the fixture, and whether chips or coolant fly at the robot. A 12 kg arm at 2,258 mm reach covers most vertical machining centres; a horizontal mill with a deep enclosure often needs a longer arm or a gantry.
Cycle Time Is a Queue, Not a Number
If the machine cycle is 90 seconds and the robot needs 25 seconds to swap a part, one robot can serve two machines and still wait. Ask for the cell's throughput with the real part, not the arm's rated pick rate. Doubling machines per robot is the usual way to justify the cell.
Buffers and Lights-Out
A magazine or a pallet buffer is what turns a tending cell into a lights-out cell. Decide how many hours the cell must run unattended: 2 hours needs a small buffer, a full shift needs a pallet pool and a part-presence check at every station.
Safety and Access
The operator still has to change jaws, clear jams and gauge parts. Design the fence around the operator's route, not around the robot's reach, and use a safety scanner on the load side so the cell keeps running while someone walks past.
Questions We Get Asked
Can you tend a machine with a cobot instead?
Yes below roughly 10 kg and with a low-speed approach. The advantage is no fence; the cost is cycle time and reach.
Do you supply the gripper?
Yes — double-jaw, three-jaw, vacuum or magnetic, sized on the part drawing. Send the drawing and the machine model.
What about part cleanliness before gauging?
Add an air blow or a wash station in the cell; measuring a wet or chip-covered part is the most common cause of false rejects in tending cells.
Machines This Applies To
- ROKAE NB25H Series 6 Axis Industrial Robot - 12kg Payload, 2258mm ReachNB25H · 30 days
- Industrial 4 axis scara robot 600mm with 3kg payloadTR600B · 15 days
- 6-Axis Spot Welding Robot, 1,950 mm ReachTR-SW6-1950 · 35–45 days
Ask an engineer about your case
Keep Reading
- What documents ship with a machine (and what to ask for before you sign)Manual, drawings, I/O list, spare-parts list, FAT report, packing list. Missing one of these turns commissioning into a month of emails.
- Glass facade cleaning robots: what a building actually has to provideThe robot is the small part of the decision. Anchors, water, roof access, wind limits and the contract with the cleaning crew decide whether it ever gets used.
- Exoskeleton selection: passive or powered, and which body part actually hurtsPassive units borrow energy from posture; powered units add torque. The right choice depends on the task duration, the load, and whether the worker walks or stands.