Skip to content
Sales engineers online · 09:00–21:00 CST Bao'an, Shenzhen, China
Buyer tools · sizing

Robot Selector: Payload, Reach, Axes

Enter the duty. The shortlist is built from published specifications only, ranked by the smallest adequate platform — not by what is in stock.

Sizing Inputs

How much headroom over the part weight and gripper.

Units: kg and mm. Nothing is stored; the URL carries the question.

94 platforms in the matching range (1.2× margin). Top 4 by fit shown. Matched from 94 candidate entries in this platform family.

Just Under the Duty

These carry a published figure but miss a criterion — useful when the duty can be trimmed.

Nothing sits just under the duty.

If the Shortlist Is Empty

A 6-axis arm on a 7th-axis track, a gantry or a delta cell can cover envelopes no single arm reaches. Send the part drawing, the target rate and the destination port; the reply is a cycle estimate, not a brochure.

Send the duty

Have the Shortlist Checked

An engineer re-runs the sizing against the part drawing and the cycle rate, and replies with a firm scope within 48 h. The shortlist above travels with the request.

We reply within 48 h. No newsletter, no reseller list.

Method

Why the Top Card Is the Top Card

Ranking
Smallfirst
Smallest rated payload that clears the duty at the chosen margin, then the reach closest to the target — an oversized arm costs cycle time and money.
Reach
+150mm
Measured to the tool centre at the worst-case point of the envelope, not at the wrist flange.
Axes
6default
4 axes suits pick-and-place; 6 is needed to hold an orientation through a weld or a dispensing path.
Coverage
41of 551
Products publishing both payload and reach. The rest are never guessed at — they are listed as envelope on request.
FAQ
What payload margin should I use?

1.2× the part, gripper and tool weight is the working default. Use 1.5× when the arm accelerates hard, holds the load at full extension, or the tool is heavy: acceleration torque, not static weight, is what breaks a duty.

Why is the reach measured to the tool centre?

A published reach is measured to the wrist flange; the gripper adds 100–200 mm. A cell sized to the flange figure misses the far corner of the fixture or the pallet.

Can I size a cobot with this tool?

Yes — choose the collaborative platform family. Cobots are ranked the same way, but check the shared-space requirement separately: force and speed limits are set by the risk assessment, not the datasheet.

Do prices appear in the shortlist?

No. TROY quotes per configuration, because the arm is 30–50% of a cell. Ask for the cell price with the cell scope, not the bare arm.

What if the part is heavier than anything listed?

Above 300 kg the answer is usually a palletiser column, a gantry or two robots cooperating. Send the part drawing and the rate and it is scoped directly.

TROY AssistantSales engineer · replies in seconds
Hi — I’m TROY’s sales engineer bot.
Tell me what you need to automate: part weight, reach or cycle time is enough. I answer in your language and can put you in front of a human engineer in 48 h.
No prices published — quotation per configuration within 48 h · quote form